Products

SUPPORTS FOR PLATE-MOUNTED ELECTRODES

COPPER ALLOY ELECTRODE HOLDERS

SUPPORTS FOR PLATE-MOUNTED ELECTRODES

A.T.S. is a qualified supplier of plate-mounted electrode holders used in resistance welding.

On medium and large resistance welders, there are plates on which electrode holders are mounted.

The plates that are mounted are parallelepiped-shaped and have slots, inside of which we hammer nuts to secure the support, once the upper part is aligned with the lower part.

Under these conditions, it is always advisable to work towards the centre of the cylinder in order to avoid bending.

When this possibility exists, cylinders with trapezoidal guides sliding on ball bearings should be used to avoid bending or slipping of the electrode during welding.

Even in this case, a very good cooling system is necessary considering that these are always medium to high power welders.

A.T.S, can supply the most suitable plate-mounted electrode holder for your needs.

Informative

We and selected third parties use cookies or similar technologies for technical purposes and, with your consent, also for other purposes as specified in the .
If you close this banner with a tick or click on "Decline", only technical cookies will be used. If you want to select the cookies to be installed, click on 'Customise'. If you prefer, you can consent to the use of all cookies, including cookies other than technical cookies, by clicking on "Accept all". You can change your choice at any time.