Products

STRAIGHT ELECTRODES FOR SPOT WELDING

ELECTRODES FOR RESISTANCE WELDING IN COPPER ALLOYS

STRAIGHT ELECTRODES FOR SPOT WELDING

Straight copper alloy electrodes with a drill in the center for resistance welding are always the best solution to perform the resistance welded joint of two sheets.

The straight electrodes with the tip in the center allow their internal cooling as defined by the rules defined by the resistance welding, the full part of the electrode should never exceed two centimeters and the inner cooling tube to the welding electrode, must reach one centimeter from the end of the hole and cut to 45°.

The cooling hole on the straight copper alloy electrode and the diameter of the inner cooling tube, must be proportionate to the diameter of the welding electrode and depending on the welding current.

An additional advantage in using the electrode straight with the tip in the center is that you can make the dressing of the tip using a manual pneumatic sharpener ETD-18 equipped with the blade with the suitable profile at the tip of the electrode for resistance welding.

Informative

We and selected third parties use cookies or similar technologies for technical purposes and, with your consent, also for other purposes as specified in the cookie policy.
If you close this banner with a tick or click on "Decline", only technical cookies will be used. If you want to select the cookies to be installed, click on 'Customise'. If you prefer, you can consent to the use of all cookies, including cookies other than technical cookies, by clicking on "Accept all". You can change your choice at any time.